RemoteApps: remote working (Windows)
As of March 1st 2022 RemoteApps will only be available for employees of the DGK faculty to make use of Vetware and/or Glims.
RemoteApps is used to start applications from any computer, wherever you are. It does not matter whether you are using a personal or UU device, at home or on the road.
Required for the use of RemoteApps are:
- A stable internet connection
- Two-factor authentication
All other applications for employees and education have been made available on SolisWorkspace.
Are you using a computer from or at the University? You may then skip step 1 to 11 and start the manual at step 12.
Make sure you have an active internet connection. At the University you can connect to the wireless network eduroam.
N.B.: the following steps and screenshots may differ slightly depending on you operating system and browser.
Go to https://remoteapps.uu.nl
Sign in with you Utrecht University mail address and password.
Enter the verification code.
If you do not see this screen you may still need to set up your two-factor authentication.
Click “Detect Receiver”.
Check I agree with the Citrix license agreement and click Download.
Save the file and run the installer.
Check I accept the license agreement and select Install.
Wait for the installation to finish and click Finish to finalize the installation.
If you see the screen above:
- Click “Citrix Receiver Launcher”
- Check “Remember my choice for receiver links”
- Click “Open link”.
(Re)start the browser and go to https://remoteapps.uu.nl
- Sign in with your University mail address and password
- Complete the two-factor authentication request
You are now singed in to RemoteApps.
RemoteApps starts with the Favorites page by default. You can add your preferred apps here. Click APPS to see all available applications.
All available applications can be launched from this overview by simply clicking the icon.
When opening an application Citrix Receiver may prompt you for access to your computer. If so, check “Do not ask me again for this site” and click Permit use or Permit all access.
Last modified: 25/02/2022